diff options
Diffstat (limited to 'conf.d.Linux')
| -rw-r--r-- | conf.d.Linux/net.example | 76 |
1 files changed, 38 insertions, 38 deletions
diff --git a/conf.d.Linux/net.example b/conf.d.Linux/net.example index 927a5c23..ba043eaa 100644 --- a/conf.d.Linux/net.example +++ b/conf.d.Linux/net.example @@ -647,61 +647,61 @@ # The PPP daemon has many options you can specify - although there are many # and may seem daunting, it is recommended that you read the pppd man page # before enabling any of them -#pppd_ppp0=( -# "maxfail 0" # WARNING: It's not recommended you use this +#pppd_ppp0=" +# 'maxfail 0' # WARNING: It's not recommended you use this # # if you don't specify maxfail then we assume 0 -# "updetach" # If not set, "/etc/init.d/net.ppp0 start" will return +# 'updetach' # If not set, "/etc/init.d/net.ppp0 start" will return # # immediately, without waiting the link to come up # # for the first time. # # Do not use it for dial-on-demand links! -# "debug" # Enables syslog debugging -# "noauth" # Do not require the peer to authenticate itself -# "defaultroute" # Make this PPP interface the default route -# "usepeerdns" # Use the DNS settings provided by PPP +# 'debug' # Enables syslog debugging +# 'noauth' # Do not require the peer to authenticate itself +# 'defaultroute' # Make this PPP interface the default route +# 'usepeerdns' # Use the DNS settings provided by PPP # # On demand options -# "demand" # Enable dial on demand -# "idle 30" # Link goes down after 30 seconds of inactivity -# "10.112.112.112:10.112.112.113" # Phony IP addresses -# "ipcp-accept-remote" # Accept the peers idea of remote address -# "ipcp-accept-local" # Accept the peers idea of local address -# "holdoff 3" # Wait 3 seconds after link dies before re-starting +# 'demand' # Enable dial on demand +# 'idle 30' # Link goes down after 30 seconds of inactivity +# '10.112.112.112:10.112.112.113' # Phony IP addresses +# 'ipcp-accept-remote' # Accept the peers idea of remote address +# 'ipcp-accept-local' # Accept the peers idea of local address +# 'holdoff 3' # Wait 3 seconds after link dies before re-starting # # Dead peer detection -# "lcp-echo-interval 15" # Send a LCP echo every 15 seconds -# "lcp-echo-failure 3" # Make peer dead after 3 consective +# 'lcp-echo-interval 15' # Send a LCP echo every 15 seconds +# 'lcp-echo-failure 3' # Make peer dead after 3 consective # # echo-requests # # Compression options - use these to completely disable compression # noaccomp noccp nobsdcomp nodeflate nopcomp novj novjccomp # # Dial-up settings -# "lock" # Lock serial port -# "115200" # Set the serial port baud rate -# "modem crtscts" # Enable hardware flow control -# "192.168.0.1:192.168.0.2" # Local and remote IP addresses -#) +# 'lock' # Lock serial port +# '115200' # Set the serial port baud rate +# 'modem crtscts' # Enable hardware flow control +# '192.168.0.1:192.168.0.2' # Local and remote IP addresses +#" # # Dial-up PPP users need to specify at least one telephone number #phone_number_ppp0=( "12345689" ) # Maximum 2 phone numbers are supported # They will also need a chat script - here's a good one -#chat_ppp0=( -# 'ABORT' 'BUSY' -# 'ABORT' 'ERROR' -# 'ABORT' 'NO ANSWER' -# 'ABORT' 'NO CARRIER' -# 'ABORT' 'NO DIALTONE' -# 'ABORT' 'Invalid Login' -# 'ABORT' 'Login incorrect' -# 'TIMEOUT' '5' -# '' 'ATZ' -# 'OK' 'AT' # Put your modem initialization string here -# 'OK' 'ATDT\T' -# 'TIMEOUT' '60' -# 'CONNECT' '' -# 'TIMEOUT' '5' -# '~--' '' -#) +#chat_ppp0=" \ +# 'ABORT' 'BUSY' \ +# 'ABORT' 'ERROR' \ +# 'ABORT' 'NO ANSWER' \ +# 'ABORT' 'NO CARRIER' \ +# 'ABORT' 'NO DIALTONE' \ +# 'ABORT' 'Invalid Login' \ +# 'ABORT' 'Login incorrect' \ +# 'TIMEOUT' '5' \ +# '' 'ATZ' \ +# 'OK' 'AT' # Put your modem initialization string here \ +# 'OK' 'ATDT\T' \ +# 'TIMEOUT' '60' \ +# 'CONNECT' '' \ +# 'TIMEOUT' '5' \ +# '~--' '' \ +#" # If the link require extra configuration - for example wireless or # RFC 268 bridge - we need to depend on the bridge so they get @@ -1020,7 +1020,7 @@ # # Enable Wake-On-LAN for every interface except for lo # # Probably a good idea to set RC_DOWN_INTERFACE="no" in /etc/conf.d/rc # # as well ;) -# [[ ${IFACE} != "lo" ]] && ethtool -s "${IFACE}" wol g +# [ "${IFACE}" != "lo" ] && ethtool -s "${IFACE}" wol g # Automatically erase any ip rules created in the example postup above # if interface_exists "${IFACE}" ; then |